Recent content by mark kelly

Hi all, Some expertise required. I have three of the pyronix dome cameras and I cannot connect them to the Pyronix cloud app. However I can connect each camera to my local network using the “ADD” button. I have a New sky router, so I split the 2G and 5G signals, then disabled the 5G so only...

Hi, Yes I have changed mobile phones and installed the app on the new phone, its exactly the same. I get the messages on the new phone but not the voice, on the old phone I still get the voice and message. They are both iphones running the same ios. Same with my ipad just the message and also...

Hi, Some more Pyronix issues, was hoping the usual experts can help... Firstly... Can anyone tell me how to get voice push notifications working on my iPhone and iPad? I get the messages (armed/disarmed) but not the voice message which I used to at one point. Secondly... Can the...

So can anyone help with Pyronix cameras ie the movement alarm...? As usual jack $hit information anywhere... PLEASE

Why is Pyronix stuff so so so so painful. Can anyone tell me how to get the motion detection/alarm notifications working from the new Pyronix WiFi based dome cameras. I have enabled it in the app but nothing works....... as usual. Cheers Mark

Hi, And thanks to all that replied. Well the panel is now working and there was no fault, just me being stupid. Basically after I triggered the alarm I was not waiting long enough for the dialler to dial out. The book says it rings after 15 seconds, however this time I waited around 30...

Following on from this, changed to a 1pMobile Sim card which I am assured will operate under 2G. Still no joy. The alarm will text me when arming/disarming and when I do a oice dialler test it will dial my number. However, when I activate the alarm it does not ring me. Has anyone any ideas or...

Hi, Moving on from my Enforcer issues, which are now solved thanks to this forum, I decided to check my Yale HSA6500 which I used on a garage I have to make sure the dial out worked. This garage is located not far from where I live so I needed a cheap and cheerful alarm that would ring me in the...

Hi all, Well, I tried the D+, and the D- as recommended and the panel sprang to life. Set it up as per the book and it all works. So thanks to all who helped. Just some notes if anyone else gets stuck... 1) The supply is connected to the +12V/)0V as shown in my previous posts. 2) Bell and...

Extra security. I have internet access and use the App, but sometimes my internet dies. thanks Mark

Hi, Thanks for the reply. I took the supply straight from the +12v/Com on the Input/Output board, and measured this at about 13vdc with my fluke. I'll try and connect as per your suggestion in the morning. Can you avise on the other points I asked.. ie does the bell signal produce a +12volt...

Well, Just got around to mounting my V2GSM Pyronix module and as usual with Pyronix stuff its a chew, no help from the retailer at all, what a mistake buying this crap, just like their cameras but thats another topic.. Anyway, heres what I have done... 1) Took +12VDC and the Com from the...

Hi, Thanks for the reply @sparkymarka. Just to clarify then... So I take a single wire and connect it to the BELL signal terminal on the enforcer and connect the other end to say input 1 on the V2 GSM thats just a single wire right? And leading on from the above, then would I need to program...

Hi, Tried to get these cameas going again, low and behold worked first time. I reckon the app had issues, now working fine. thanks Mark

Hi, I was hoping that someone on here could help me out. I need to connect my enforcer to my V2 GSM module so that when the alarm goes off it rings me. So, my questions are.... 1) Can I use the +12vdc and COM terminals on the enforcer I/O board to power the V2 GSM module or do I need a...