markjg123's latest activity
-
The light fitting wiring can never be overloaded by a 10w bulb, but I get ya (y) -
markjg123 replied to the thread Light switch spur.Thanks. This is a really clear and helpful description.
-
The ceiling rose, lamp holder, and flex, will likely only be rated for 6amps, so I would suggest a 5amp fuse to protect those.
-
If you put an fcu before the socket you dont really need a second fcu just a light switch as the original 13 amp fuse will protect the...
-
Basically, with a Ring Final Circuit you can run a Radial Leg (Called a Spur) from it either fused down or not - the max load on that...
-
markjg123 replied to the thread Light switch spur.I don't think I have any 1.5mm or 1mm T&E, so should I stick with the 13A fuse if using the 2.5mm into the light fitting?
-
markjg123 replied to the thread Light switch spur.Great. Thanks for the help. Is it OK to use the 2.5mm T&E between the FCU switch and the light fitting?
-
In that case you'd need an fcu before the socket then you can feed your light from the socket via a switched fcu.
-
markjg123 replied to the thread Light switch spur.I can't locate a FCU, so I'll have to say it's unfused direct from the ring main.
-
I want to install a light in a cupboard I'm building. My plan was to spur off the existing socket to a 13A fused light switch. I say...
