Recent content by Marti64

Hi, managed to get the part and after a few test runs, the problem is fixed now. Thanks for all your help, it really is very much appreciated. Thankyou

Thanks very much for your help. I'll post back when I've done. M

Hi, I checked the upper spray bar. It wasn't split, but it did have a piece of black rubber in it, which appears to be part of the rubber seal in the ring nut at the back of the tub. There is no resistance when the upper basket is pushed into the ring nut assembly. So would I be right in...

Hi, I pulled the machine right out and ran a full cycle. Water briefly leaks out from the front lower corners of the door, both during the soapy phase and the rinse. There isn't a huge volume of water though. When I opened the door, I got the impression that there was slightly too much water in...

Thanks. It occurs to me then that it may be a combination of a restricting blockage in the waste pipe, and the tortuous route that it takes to the drain. I won't be able to check until the weekend though. thanks again M

Hello. When using program 2, the machine works perfectly Ok until right at then end, and then it leaks cold clean (rinse?) water, onto the floor. Any ideas gratefully accepted, thankyou. Martin