Hi
My small porch is getting badly condensated. I was curious to know why and noticed that the soffits had no air vents. I removed the soffits to see what the insulation was like and found very thin insulation sheets (about 50-100mm thick), but also noticed that the insulation is on top of a...
Hi
Can anyone tell me where the coolant temperature sensor is located for a Meriva Life 1.6 8v (engine Z16SE) please?
I have the sensor and a Haynes manual but it's still not clear. And, do I have to remove other parts to access it or is it fairly straight forward? Image of how it looks...
Thanks for the reply. I will certainly replace that earth wire with the correct colour. Here are some pictures of the new switch currently wired (ignore the red wire on the far left as this will be replaced with yellow/green). Would a link wire in the com's solve it?
For the lamps, I only have two red and two black wires. There is an earth but it is not loose as it is already connected. I did have a small red link cable in the old MEM delta switch, which I have used to connect the earth to the plate at the moment.
All wires were used before and there are...
Thanks for your answer andyprk. So would that be black in L1, red in L2 and link the com's? And the linked com's wouldn't affect each other when switches are turned on/off (ie the outside lamps are not affected when the hallway light is switched on/off)?
Yes, currently have it wired with red in c and black in L1 but nothing. I have one switch plate with two flick switches (hope that makes sense). I have two outside lamps wired through together so two live and two neutral.
Hi,
I have bought a new 2 gang 2 way light switch to replace an old MEM delta light switch used to turn the lights on/off for my hallway and my 2 outside porch lamps.
I have successfully wired the com, L1 and L2 in order to get the hallway to work, but I cannot wire the outside lamps...