Recent content by mattgoody1

I'll try and chase the pipes from the cylinder to the boiler and see if I can see a leak. I think it goes straight down then across the ceiling of the garage into the boiler. So maybe between the false roof in the garage but that doesn't seem to be getting wet

There will be under the floorboards but not under concrete

It sits around 6 inches from the bottom of the tank

I'll have to do it when I get home in the morning as at work at the moment. Do you mean temp on the cylinder by stats. Sorry not very clued up

No I just have the hot water on constant on the program so comes on when needed. Thanks very much for all your help.

There's isn't any taps left on anywhere. I'm not sure about a leak as the boiler doesn't kick in for hot water until I been running the taps for a bit. Could the cylinder have air in it do you think which may stop it filling up all the way.

It's a mixer tap with shower. Other taps are fine. The bath gets red hot but just not enough hot water to fill it. Gets around a quarter full then goes cold. Was one until this little leak. Would it have something to do with the cold water tank level been an inch lower ? Just seems very strange...

It's set at 65. Not sure of how long the boiler runs for to be honest sorry. No it's not overflowing it now stops around an inch below the overflow pipe

The boiler as emersion was disconnected a few years ago

Hi all I'm new to this site and after some advice. Came home to a leak from cold water tank in the loft. Was leaking from the hole at the top for the overflow pipe. I have fitted a new float which has lowered the level by an inch which has solved the leak. I've also extended the pipe for the...