Recent content by MatthewHUB

Sorry Big All for the late reply, i've been abroad. I haven't taken any time for fine adjustment as i'm not really sure what to do. I have to stick bits of paper into where the mitre fence attaches so that it runs paralell with the blade! In terms of assembly, there was LOADS of stuff to do. The...

Hi guys my new saw came, and the defective one was collected and i'm so so soo so so pleased with it! I spent about 3 hours putting it all together but thank god it was aligned properly this time! I was using it all afternoon and made some good looking tenons for my bench. I'll have to post some...

Hmmm Petewood that's not what i wanted to hear! Well i'll see when my new saw arrives. i hope it comes tomorrow - Who knows, maybe i won't have to do anything to it! Btw, is there an english equivalent of the delta tenoning jig for table saws? Or how else can the be done on the table saw? M

Yes of course i checked it wasn't at an angle! It was tilted to the right as you look at the saw about to saw something. the end of the blade closest towardsa you was correct, but then the whole blade did not run parallel with the rest of the table, and it went off to the right. Does that make...

Hurray i received my saw today! The ryobi one mentioned above. But sent it back as the blade is completely miss aligned. It's so stupid. As you look at ths saw, the blade was going off to the right, and i couldn't undo it and re-align it as the bolts and welded screws etc. are pretty...

Thanks all you guys for your help on this. I have ordered the Ryobi and it should come tomorow with a nice freud pro blade too. I think i can get round taking off the guard by using my router and other equipment. I have just started work on my first piece of woodworking - an oak bench! Btw, how...

OK guys thanks a lot for your quick reviews and blade suggestions. I wish to be able to take the guard off for things like cutting grooves the whole length of the wood etc. Can this be done with the Ryobi? Does anyone have any experience of how difficult it is to take the guard off on this...

Cheers guys, I had seen that one and thought of it too... but was just a bit sceptical as i went to B&Q and saw a few in the flesh and deciede there weere a lot that looked tacky. Ah well, if you guys say that Ryobi one is good i'll go for that and try and get a dogs danglies blade. What do you...

Hi guys, I'm fairly new to woodworking and i'm looking to buy a cheap table saw to make some things over the summer. My budget is about £150 max, and i'm looking for something with a depth of cut around 75mm, with stand (and preferaby a removable safety thing so just the blade sticks out). I...