Eek... Cheers Danny, I think this was the one I meant! Looks spot on to me!
http://www.plumbnation.co.uk/site/gledhill-fortic-f1-combination-vented-copper-hot-water-cylinders---direct/
I have two lengths of four by two set into the walls which I was hoping to utilise. It seems that 900 is the smallest height you can get for the copper tanks though... :(
Thanks mate. I was just looking at this one... At 900mm high, it would just about fit into the current space, with about 40mm to spare... Let me guess though, a pipe has to go straight into the top, meaning it's too high..?
Hi again fellas...
As expected Elson no longer produce anything like what I had there. To be honest, I expected this whole 'finding a new boiler' thing to be a slightly expensive piece of cake, but I really have no clue what to buy...
I'm happy to adjust the pipework as required and change...
Thanks for the replies guys. Funny enough, I just had a look and the tank I just ripped out was made by Elson! Must be a good company if they're still going! Think I'll drop them a line and see what they have to offer! Thanks again chaps!
I have just removed a very old square tank immersion heater from my flat. After considering the few options of what to replace it with, given that the flat is electric only, I have decided that I'd like to replace it like for like if possible. My grandad was a boiler fitter up until about twenty...
Hi
This is my first post on the forum, and it is a pretty simple question and I'd like some advice...
At the moment my flat has electric heaters. They are controlled by a switch next to the radiator and also a switch and separate thermostat on the wall at the other end of the room.
I...