As it's our only upstairs toilet i was hoping to be able to find a replacement/parts in advance rather than dismantle it/investigate and be without a flushing toilet as i wouldn't be popular in our house :)
We've got an old overhead chain pull cistern on our bathroom toilet. Ever since we've moved in it's always needed several pulls on the chain in order for it to flush. I'd like to replace/refurbish it but i'm struggling to identify the make or a suitable alternative. Does anyone have any ideas on...
get one of those cheap usb endoscopes off ebay that plug into your phone, drill a small hole in the mortar to the cavity at the top of the damp section (or drill out one of the perpendicular (upright) mortar sections to give you a bit more wiggle room) poke it in there and have a look. They...
We've got an old farmhouse with a pantile roof, alot of the ridge & valley pointing has failed so we're going to have them fixed/rebedded/pointed. Have any roofers on here got any views of flexim roof putty? I'm thinking of using it as to me it seems a more flexible and durable product than...
We've got an old farm house which is in a L configuration. The attic has been converted at some point in the past by previous owners. It has a vaulted ceiling with oak purlins running down the length of the room. At the elbow of the room one of the purlins blocks an alcove however it didn't...
The loft in our old farm house has been converted at some point by a previous owner, however its absolutely freezing up there in winter and so we need to do something about it.
I've done some investigation and found that when then did the renovations previously they seem to have used ~25mm...
Hi
I'd welcome some advice in regards to the slate roof verge detail required on my new garage build.
I'm clear on the setting out & fitting process for the battens & tiles it's just the detail of verge I'm a bit unclear on.
Would someone be so kind as to point me in the direction of a decent...
ah *******s :(
yes all 3 ends disconnected
thanks very much for the advice everyone
can anyone recommend a good brand of these joints because I'm not convinced of the quality of the last one we used. ie the plastic felt cheap and brittle and there was no spacers to ensure the connectors...