Recent content by Mike0287

Thanks again for your replies, it's really helpful. I must admit I'm not sure on the terminology for all these different floor types. Not sure if they used a water mix or latex etc, I just know it's the stopgap 1200 pro. And yes that's my main argument with them now, I feel as though they have...

Have you had something like this happen to you as an installer? In that case what happened? Is the installer responsible for appropriate pre inspection and therefore makes good from their own pocket, or if it goes really wrong like this, does the customer receive a revised quote after the fact...

Hi Daz, Thanks for your replies. To clarify, they did 1 coat of P131 primer at 4-1 followed by a coat of 1200 Pro in visit one. All told they were at my property for around 1hr including setting up and cleaning down. Loads of holes, I've attached some images to show you what I mean by "loads"...

Hi Ken, Thanks for that, interesting points I hadn't considered it that way, I thought the manufacturer would rather stand by his customer (the fitter). The only issue I think I'll still have is that the fitter is pointing blame at the home builder and the manufacturer might attempt to back...

Hi Ken, Yes, certainly considered. At the time when conversation was remaining civil, the fitter was communicating with the manufacturer and relaying the information back to me. As this is going on I think I'll have no choice but to take things further myself. Unfortunately it appears the...

Thanks for your reply. I've asked about the P131 and I've been told that they diluted it 4-1 Not sure what you mean by the 28 days unless you mean waiting after the concrete has been poured? If so, the house was finished in April 2017 and so the slab would have been poured prior to that. They...

Hi everyone, I'm after some advice on some work I've recently had done in my garage by a local flooring company. Unfortunately I've been left with a large number of holes in my floor due to air bubbles coming through and the fitting company can't understand why ... I'll outline below the steps...