Recent content by mikeanthony

Here are the images of the current set up. THe ELCB is In 100A/100mA REading between all your very helpful posts (many thanks to you all) i gather that: (a) i probably need to replace both the Wylex 804 and the ELCB as they are unsafe (b) i should replace it with an RCD CU that has...

thanks for your advice Between my current Wylex 804 and the norweb electricity meter there is an Centaur ELCB 100/2/100 that has a singe trip out on it. This has tripped out in the past when i had a problem with a device plugged into one of the cellar power sockets so it has offered...

I am after some advice before I replace a Wylex 804 Ivy CU. Can i just replace the individual fuse wire blocks with slot in units that will trip out? Are these replacement units MCBs? and if so which ones best fit this type of CU? Many thanks in advance. Mike

bab/softus Thanks for your advice. I think I understand. Without a flow through radiator then the heat travels up the radiator but isnt 'replaced' or 'maintained' at the bottom. If sludging was present at the bottom then the water would still flow via the channels up and down the radiator...

:? I have one radiator downstairs which is cold along the bottom and hot nearer the top. All others are fine. Entire System only 4 years old. Could this be silting? Thermosatic Valve? Advice welcome King Regards Mike Stockport