Recent content by Mindaugas

I got answer from manufacturer. These white wires are thermal contact. Also this motor has centrifugal switch, but it is internal and I do not need any additional connection between V1 and V2. So I am going to leave these white wires not connected, or connect in series with STOP button in...

I have tried to start motor without white wires between V1 and V2 and it worked. Motor current was 4-5A. This means, that motor at startup does not uses starting capacitor, but only run capacitor? When i connected tester on these white wires, after motor start they stayed short circuited...

So I have white wires connect between V1 and V2? After that my motor starts noisy and draws 30A. I dont know where is the problem, because I connected with a given circuit diagram to rotate CW. What can happen if I start motor with the same circuit, but without white wires between V1 and V2?

My motor is Single phase ML8022 1.1kW. Here is wiring of my motor: Black (U1 and U2), Yellow (V1 and V2), Red (Z1 and Z2), and two white wires with no marking, which i tested and they are short circuited. All wires are 0,5mm2. I do not know the purpose of these white wires and could not find...

Thank you for your reply. The white wires are without labels. I have tested these wires and they are short circuited. It is possible that they are centrifugal switch as marked K in schematic?

Hello, I also have the same motor and I have a question about wiring pinout. There are 8 wires: U1 V1 Z1 U2 V2 Z2 and two white wires. What are these white wires and what they do? It is used as a contact between V1 and V2, when running CW?