Mister Banks's latest activity

Don't know if it is considered best practice but I would depending on how close they were to each other and the length.

Some systems have an additional pump and some rely on the pump in the ASHP, it depends on the overall system design, heat pump rating...

Smart TRV’s don’t work very well IME, I have Drayton Wiser, but a lot of people swear by them. WB boilers have EMS so you need either...

Surely every plumber, that I am aware of, that has installed a towel rail cant have made a mistake. I can count 12 towel rail...

I read somewhere that with towel rails you should open both valves by the same amount, so that’s what I do and it seems to work ok.

Towel rails don’t normally have lockshield valves IME, both valves are the same which I admit can cause some confusion.

My IHD was accurate when I was on the standard variable rate tariff but now that i am on the Octopus tracker tariff it shows correct...

Good video below.......

To use Vaillants ebus you will need controls form the page below...

In my case I was looking at using HA with my Wiser heating controls. There is a Wiser integration for HA but it still needed a bit of...

Ok figured it out 1. It seems to cascade boilers the extra ones need a VR32 eBus cascade card installed so you can change the id from 0...

I've used HA. There is a huge steep learning curve to get the best out of it and you will need an in depth knowledge of YAML programming...

All my pans connect to the cistern like this. You push the flush valve through the cistern hole and using the flush valves large plastic...

What do you consider to be a "significant amount of salt" and a "non-trivial amount of water"? Modern water softeners use very little of...

Are you sure the 728 is for DHW? I ask because the outside temp sensor which you say is connected to the 728 should be controlling the...