Recent content by mivec

Okay

Brilliant, that’s great the bleeping has stopped. Cannot thank you enough. Can I buy you a beer.

Sorry but which battery do I disconnect. This is better than strictly

Yes I can.

No don’t have engineers code. Took front off one sensor and alarm sounded. I don’t think anything has changed in the list.

Nothing about tamper, battery faults all zones and mains power off- I took the fuse out of the main box to try and sop bleeps a while back.

Yes

I really do want to sort this but am conscious of your time. Don’t understand your comment coming out of user mode. After the screen do you want to arm system how do I come out of user mode?

Code twice and no straight away gives message do you want to arm system. Entering yes or no still get messages. As I have taken much too much of your time can I disable the system as the bleeping is driving me nuts now. If I take the front off the panel, there is a screw underneath, I guess this...

When it’s working correctly yes , just enter code and exit. Now entering code just gets fault codes.

If I enter code twice and enter reset it scrolls through a message- zones preventing exit start area then all zones secure except one that just says kitchen ext door. If I enter code once and reset it scrolls through fault codes for when I changed the batteries. Really appreciate your time.

Hi, thanks wii give it a go. Photo attached.

I believe I have a Texacom Premier alarm system, A few months ago I replaced all the sensor batteries but now the panel bleeps for a few seconds every now and again. It does not seem to respond to the user code and I am unable to reset it. If I enter the code it just runs through a number of...

I am fitting an integrated washer/ dryer and am wondering what is the best way to mount it. The space is currently tiled so should I sit it on these or remove them and sit in on the concrete floor. Or should it be tiles and wood?

Do you mean add the socket to the FCU? If so then I would have a 3a FCU feeding a 13a socket?