Recent content by mjhill1234

  1. M

    Boiler locking out after engineer visit to measure tank!

    Thanks oilhead and Bob. That’s a fair point about the sight gauge as it was left in the open position (presuming my photo shows it closed) assuming the engineer did this. Maybe that has leaked some water into the fuel and contaminated it. The problem with the smart meter was it was reporting...
  2. M

    Boiler locking out after engineer visit to measure tank!

    Understood and yes a leak would probably not be a fun thing to have on a Sunday! Unless there is no major harm in keeping it running and resetting it I’ll try and cope until I can get a reputable engineer to come out. In my mind it was starved of oil and needed a good “run” to sort things out...
  3. M

    Boiler locking out after engineer visit to measure tank!

    Yep I would think your right there Bob, to be honest I’m better of spending effort getting things running again than wasting time going into a battle - doesn’t mean I won’t give them a hard time though No valve close to the boiler I can see unfortunately.
  4. M

    Boiler locking out after engineer visit to measure tank!

    Thank you John Yes that’s right it is a gate valve (thank you for the correct term!). The boiler has been running at non stop since I posted but it’s cut out now and there’s a bit of an exhaust smell in the garage (not crazy).... I have carbon monoxide detectors all over the house but still...
  5. M

    Premier elite 48 firmware upgrade

    Good point :-) I am based near Bicester in Oxfordshire Happy to pay for postage and a hire charge!
  6. M

    Premier elite 48 firmware upgrade

    Hi I have purchased a premier elite 48 panel and want to upgrade the firmware.... does anyone have a flash interface and usb cable they could lend me for a few beer tokens? Will save me buying and selling on eBay Cheers
Back
Top