Recent content by mjt88

** Hangs head in shame haha

Changed the gasket. Still Leaking! Found a little hole in the casing. So new pump it is! But, the replacement has different A & W values on the front of it, compared with whats already in. Does this matter? MArk

No it wasn't clear. Being a mechanical engineer my mind automatically thought you meant the actual torque being produced by the motor, as you said earlier that you suspected it was a faulty motor/pump and not the gasket. Asking if the four bolts where tight would have been a lot clearer. They've...

Did you mean check how tight the four cap heads are? I thought you ment check how much torque the motor was producing.

You made it sound like the screws to check the torque where separate to the four that i would undo to remove the silver part? Well, it is leaking. It's a trickle, but it is leaking. Mark

I wouldn't know where to even find the screws to test the torque haha. Ive uploaded a few photos. Can't seem to attach them to this reply though? It's under the album '' Pics '' It's between the silver and black, at the bottom, where it's dripping. Mark[/img]

It's not leaking from the vent hole, it's completely dry. It's visibly leaking from the joint between the body and the plastic part at the back. I could show you a photograph if you like? Yeah I would take it off and inspect it, but I'm not sure of where I would isolated the water to the pump...

Hi Tony. On the parts list there was Front and Back Gasket listed? And there four capheads that join the body and the plastic part together, can I not just open them up and put the new gasket it in? Regards MArk

Hi guys. After a little bit of advice if possible. Noticed a drip out of my boiler, took the panel off and saw that it's coming from the water pump. ( Wilo F - TF95 ) So I'm guessing the front gasket has gone. My question is, how do I isolate the water supply to the pump so I can undo the...