Recent content by mkirkby

Haven't got a clue about the load sensing valve. Not mentioned in the Haynes manual but I'll have a look later. Presumably it would be a gadget in line with the hydraulic lines.. No air coming out, haven't changed the pads/drums etc, but did change the cylinders (as you say...cheap). Was bad...

Sorry this is a long one... The brakes on my 405 have always been a bit spongy and slowly got a bit worse over time until it became dangerous. Anyway, bled all the brakes and made no difference so assumed it was the master cyclinder. Replaced that with a new one and beld all four lines...