Recent content by monoblockman

Thanks Tony, A question though, I had shut off all the rads in the system excepting the 2 which were not working, and therefore thought that the water had to go through them.. or am I thinking/talking rubbish? Regards monoblockman

Hi both, Thanks for the advice, however re bleeding, as per my first post the pressure was good and the water was clear when I slackened the bleed screw, also re balancing, (perhaps my terminology led you astray) I had opened the exit valve fully and stepped up the pump pressure as well...

Thanks Breezer Believe it or not that was plan b/ ...... but before I got involved in time and mess, I was trying to figure out why the water ran clear and why the rads stopped working after the installation, also why the top half of the rad was not getting hot. If I dissed the...

C/H system was upgraded with new boiler about two years ago. After this the system worked OK apart from two radiators running via microbore at the 'end' of the system, which did not get hot. Explanation given was that the pipes were blocked up as they were microbore. (The radiators had worked...