Hi guys,
I didn't trace the wires to the boiler at the first moment. Yesterday I opened the wiring box again and it's how you mentioned above.
The Hive is installed. The dual channel receiver is installed and working, I'm waiting the second one arrives. I took longer to pair it to the hub...
Stem, I'm sorry I mistaken the name of the HW cylinder Thermostat.
At the water tank, where are the MV, the three zones have labels and I traced the wires from the MV. So I was able to do the diagram based in what I found.
I knew that black loose cable on the drawings should go to...
Let's say I had some spare time today.
I draw the wiring how it is and how it should be after install Hive over the 2 zones.
Am I correct on the understanding after read what you wrote a couple of times?
I need a help here, please.
I have a Honeywell ST9100C that controls 2 zones and hot water tank. The zones have CM707 thermostat.
The objective is to replace these by Hive. I have one dual channel and one single channel in hands.
Checking the back of ST9100C I got confused on how to connect...
I bought a Hive Active Heating dual channel and I'm trying understand how to wire the system before go on.
This post is what best fits with what I have, but I was confused when I read:
Below there a picture of Honeywell ST9100C.
IMG_2099 by morley81 posted 4 Sep 2020 at 7:01 PM
There is a...
Hi Phil,
do you still have diagram for hive dual channel cables?
I'm about to install the same system and I have doubts on how connect the second receiver.
thanks,
morley