Recent content by mrbreckles

I immediately felt dumb after hitting reply; noticing the date. :(

I use an SMX 5000 CNC miller at work every day. Ive hardly had to do any engraving work but when i have ive always used a centre drill at the highest rpm i can get. Worked every time so far.

right, what i've done is pushthe fitting up all the way and turned it on its side so i could grab the levers on the one side with a finger and pull them through, then just pulled down hard and the other one popped through with a pretty big bang bit it worked. Worked in the sense that all i need...

i can push the fitting so it goes completely up. i can see the floorboards/concrete of the above apartment's floor. So basically grip either side of the fitting and pull down until the 2 smaller clips are forced down and to spring out under the edge of the hole ? Wont this be to much force...

Disaster. Im renting and the bulb went in one of the 6 spotlights in the kitchen. So, purchased a new one, come to fit it and the actual fixture itself has moved. unfortunatly i cant take pictures so ive used my amazing skills with paint to try and illustrate the problem. The red...