Recent content by mrpaint

Hi james thanks for the reply I already printed the installation manual and user manual Just when it came to flue bit it just looked like twin pipes...and thought I could make that pretty easy ! Thanks again for your input

I am going to have a pro look over everything and do the final set up /checks and any alterations that's required . I am very confident and take a lot of pride in my work the reason I am asking all these questions . I will also check the building regs for boiler and flue positioning ...

Maybe if you actually read the first post you would see I said "Next room is the 3 sided building where the boiler was going to be situated" Before you try to rip the **** please read :roll: :roll:

Hi, Oil head Thanks for the reply I shall seek advice

Also the boiler is a worcester greenstar ii he 12/22 Thanks

Not taking the mick mate ! I thought I could do all the pipe work and get local guy to check over and connect the fuel feed and return ? dose it need to meet regs in a workshop ? Thanks

Hi dan its just a farm outbuilding but only has 3 sides not sealed room Thanks Tommy

No it dose not have a flue atm I bought it second hand to heat workshop Hence the question do I need to buy one ? or dose it need to have one connected to run if its in a open vented barn . That's why I was asking the questions if it was 2 bits of pipe inlet and exhaust . please remember...

Hi is a balanced flue anything special ? dose it have to be certain length etc I have an old oil fired boiler for the workshop heating. next door is a open vented un used barn room The boiler is going to be installed in this room but my question is do I need a flue ? or can I...

if there was no valve in place what could happen or would it just boil the water ? Thanks for the reply Tommy

Hi we are looking to heat our workshop so we bought a oil fired boiler and are looking for some advice on fitting the vented system please . boiler is worcester greenstar ii he 12/22 we have 3 double rads and a hot water cyl to install. cylinder in out 22mm copper, rads are 10mm micro...

thanks any other advise please

Hi. I need to cut a 300m duct into the workshop roof ..... the roof is made of cement asbestos corrugate roof panels . The plan was to mark the hole then cut the hole by using a air saw and spraying the area of the cut with soapy water...will be suited and booted using my painting mask...