Recent content by myboys

does an rsj in the ceiling void between two rooms in a normal house need to be dooble boared for fire protection

is it ok to apply acoat of pva to a newly plasterboarded wall to slow the skim down from going of to quickly

is it ok to apply a coat of pva to a new plasterboard wall to slow the skim down from going off

could you screw a strip of approx 75mm timber to the inside of the drawer box through the sides and base behind where the drawer front sits then screw the front to this screwing through the back into the thicker part of the drawer front not the thinner panel.

zanussi double oven keeps tipping fuse board when main oven is switched on have replaced the element 3 weeks ago but has started to do it again any advice would be great thanks

mine was in a waste under kitchen sink and still froze

was the door stored leaning against a wall before fitting this can some times cause a bowing affect

raising the floor level would create a step and am reluctant to do this also would affect the lintel height and cause problems with an existing padstone. have seen the kingspan product today and will make inquiries about this. thank you both for your replies

i am thinking about converting an integral garage into habital room the difference in floor levels is about 35mm at the new doorway the bco has asked about insulation in the floor there is no insulation in the existing garage floor are there any options other than taking up existing garage...

i find laminate flooring works out cheaper in the long run but as with most things in a rented property it will only be as good as the tenant if they did not pay for it why should they look after it was a response i once recieved

you can buy a screw on type that goes on the closing side screwfix does them p232

is it possible to use stud iron rods and bolt right through the wall. washers and nuts either end that is a big cupboard

i would using a good quality construction adhesive to glue and screw a 3/4 ply panel to the wall when you drill the holes for the plugs force in as much glue as you can put in the plug allow and to set and glue the back of panel to the wall prop up till set then screw units to this using...

does not need to be fireproof i would personally use 19mm mdf for the lid and 3x2 or 4x2 trimmer depending on existing ceiling

would mitre mate hold the joint tight