Recent content by neerday

Is that something I can do easily myself? It might be quite handy especially when the weather is milder but still want a bit of heat. Looked in the operating instructions but not mentioned there.

Thanks for that Bunny. I suppose with your rule of thumb I'd want about 27kw so as you say the installer maybe set it down a bit. No problem anyway as I say, the house warms up quickly enough.

I have had a Vaillant 630 system boiler for a couple of years and I have noticed lately that the LCD display showing the boiler output never reaches full scale (usually about 3/4 or a bit more). Seems to working OK and goes up and down a bit, just not at maximum. It's maybe always been like this...

Following my previous question about the mcb rating I've nor measured the wiring resistance to the garage. What I did was to join all 3 conductors in the swa into a brass earth block in the garage and measure between them at the house end. I get approximately 0.8 ohms between each pair (live...

I think the point of the question is that if you have a CH header tank in the loft and the loft radiators are about level with or above it you are going to have to do something about it.

Not notifiable in West Lothian so far as I'm aware. If I were an electrician I wouldn't ask these questions eh? The reason for asking was that I felt that 2.5mm single was likely not rated to 30A. Now I know I'll fit a lower rated mcb. However the 30A fuse has been there since before I owned...

I've changed my old fusebox for a new consumer unit. I labelled all the wires and put them into the correct mcbs in the new unit with the socket rings, and garage on an rcd. Don't have an electric shower and the general advice seemed to be not to put the cooker on the RCD. I selected the mcbs...