Thanks for your help everyone.
Finally got around to doing it, used the loctite 55 with about 9 turns on the elbows and 7 or 8 on the straight. Picture is attached of what it now looks like.
Thanks again!
I have used the wrong fitting for one..
And I've tried ptfe and tru blu from rectorseal, ptfe enriched liquid. But I think these fittings and the loctite should do the job. I hope!
Thank you both for the help. I'll drop another message on here if I still have problems
Sorry, this shower has stressed me out.
I need them to come out and 90° angle down to face the floor as attached, but when I hand tighten them on they are facing up, not sure if the loctite 55 will change this as I will still need to tighten the connection?
I could do with the angled ones from the toolstation link as my feeds come up, but I cannot get them to point down to the feeds and tight? Thanks for the help guys!
I used an angled one and I would not have been able to connect the feeds. I'm guessing a straight like in the picture I've attached is the connector to use?
Hi all,
I am fitting a concealed shower and I am struggling with what to connect into the mixer with. It has female 1/2" but when I've tried Male 1/2" they are not at the right angle for me to plumb the hot and cold feed??
Any help would be great!
Nick