Recent content by NickMDal

Think I got it. A bread knife to shave off a wedge shape from the bottom rear, up to about 2 inchs. Then slide the bolster under since it will give easily. Add glue to the removed part and place it to dry, since the remaining foam already passed under tight area. Hope someone need to do...

Hi. I have a large kayak that uses 3 parallel dense foam bolsters under the floor to make it easier to stand on. They are about 24" long, 8" high and 4" wide. One of them tipped over. It was very difficult to remove it since space is tight. I applied soapy water and wet the interior. After...

Ohhh... I thought you were joking! You know like one of those pliers multitools? I like this suggestion! Thanks so much :)

I guess I could buy a wood planer and just try. That and sandpaper on a block should do it. Thanks!

:unsure:

Hi. I have a kayak with a DIY storage area in the bow. Just added a trap door. Inside I created a mold and filled it with light weight 2 lb. pour foam. I then pushed a flat cardboard box (the shape of a lithium battery) onto the foam to create a seat/shelf. The idea was to create a flat...