Bit of a Update i opened up the Control unit and this is how currently how the wiring is wired up does it look right?
I have not wired up the second bell box yet but thought I would take a look inside the panel.
Another thing When i opened up the panel the backup battery is knackered , now the...
Hi Ok So Do i put the Jumper on the front house siren into SCB and LC on the Siren Box PCB . Or Just on The Rear Siren box which i am going to fit.
And then double up on the wires from the Accenta control unit to the rear house siren?
Sorry new to this !
Hi All i have The Accenta 8 Mini Alarm System I currently have 1 Siren with Strobe Unit connected to front of the house and a internal Siren , I wanted to know if i can add another Siren at the back of the house Into the Accenta 8 mini control unit.
I cannot see where i could connect up a second...
Hi so did yours have the same issue where the pin does not come out enough to push the micro switch , and this kit fixed that problem or your DV was leaking ?
I have changed the lateral pin nut earlier in the year because mine was leaking but not the top nut which is the one which does not come...
Yes so far so good has not lost any pressure since pumping it up
Only issue i do have is on the diverter valve the little pins which come out and push against the micro switch does not always come out meaning the boiler does not ignite
Only the vertical one seems to play up .
Hi all I want to fit one of these filters to my boiler as I currently do not have one
Due to limited space on my return pipe I need to fit the micro filter
Now there is two types a Magnaclean micro and micro 2 anybody know the differences?
Hi all I pumped up the original vessel over the weekend and so far so good has not lost pressure on gauge when CH has been on and off
Another question the drain point on the right hand of my 2nd pic on the return pipe Is that where I would drain the radiators / sytem from I'm assuming this will...
Hi so the filling loop pipe line which goes to the 22mm left side in pic this is not where you would connect a remote vessel as that is a feed into boiler?
So I would connect it to the R/H 22mm that is the CH return right ?
Ok I can give that a go I was under the impression if it leaks out of the expansion valve the the vessel is shot if I still press it water is still trickling out slowly
# Update I managed to taking the panelling off around the boiler and gained access to the vessel valve I pressed it and some water came out with very little air and rest of the air seems to be expelled
Can I just try topping it up or does water indicate vessels shot?