Recent content by ninro

We need to secure a 1200mm gate post to a brick wall for the same height and width gate. Will concrete screws into brick be strong enough? Its a cavity wall so should screw go just into brick or be long enough to penetrate blockwork? Most videos online are using thunderbolt type screws but they...

It's a pain that now I'll have to double check their work and interrogate as to what breaker they're going to use, is it bi directional etc. I'm told that many still aren't using these which seem important for pv, battery. I've garnered from electrician videos on YouTube that this is often an...

One thing I've confirmed with fox UK support is that the breaker should be at least 40a.

Probably best not to name our installer. Give them time to rectify. They are reputable.

I should add resetting the breaker has not brought the system back up. Its still gives a grid lost fault. Would this be due to damage to the breaker after it tripped?

Don't quote me on what I think cables do or go exactly where, unsure of that but here's a photo of the cables. Both dc coming from pv and to cu. This what you would expect?

Yeah, found some on my phone. Second was yesterday for evidence of trip.

Thanks, so this uk version says the breaker should be 80a for our install with battery. Still a lot bigger than the 32a that was used. On a foxess forum a couple of people reckoned a 40a would do.

It's the k series 7kw, not using eps but we charge a battery overnight, ep11 bat.

Yeah, I've contacted their UK support who may have a different view on what's required.

It's a fox ess k series 7kw inverter, like most it's chinese.

This is from inverter manual. We have the 7kw inverter, 8kw of pv and 10kwh battery

Here's the inverter manual. We have a battery to charge also.

We just had our solar and battery install trip on the cu. It was a 32a breaker. Having looked at the manual for our inverter it actually states this should be 100a breakrr and the cabling should 13mm². I can't seem to find this size wire when I look on uk sites. Is it non standard in the UK...

I had a plumber tell me a vent flat with the roof tiles could allow gases into the roof space so not suitable. Think he said vents should possibly go up at ridge and our location was too low?