Recent content by Nje

  1. N

    System setting fault on empty zone

    Problem resolved. I must be cracking up because I thought I posted my solution but can’t see it so I must have forgotten to press ‘post reply’ I must have pulled the wire when moving the RKP and as a result the stripped part of the green and yellow tamper wires were touching and this is what...
  2. N

    System setting fault on empty zone

    Emergency over!!! I rechecked it again and found that the tamper wires from the RKP were touching in the terminals in the control panel, I must have pulled the wires when putting the lid back on. All is working ok now, thanks for previous help
  3. N

    System setting fault on empty zone

    I’m sorry but it’s going from bad to worse, I’m starting to think like my wife that something faulty, ( could be me!) I decided to go the whole hog (still on the table) and connect 3 sensors and the bell box for a final test before installing it properly. It starts off with the bell sounding. I...
  4. N

    System setting fault on empty zone

    Excellent, thanks very much
  5. N

    System setting fault on empty zone

    Sparkymarka - thanks, spot on, all seems well now although when setting it (remember it’s still on the table in the dining rooom) it suddenly chirped up with ‘setting fault zone 1’ and then went back to setting. I can still hear my wife (for about the 30th time ) saying “send it back it’s...
  6. N

    System setting fault on empty zone

    Update. Initial success and then failure.!! I linked all zones other than those with sensors connected and success, I set the alarm and they picked up my wife moving around and the alarm sounded. I then decided to tidy up the wiring a bit. I removed all 3 PIR’s and then refitted them all. On...
  7. N

    System setting fault on empty zone

    Thank you for both of your replies and suggestions. Sounds like a plan. I won’t be home until about 3.30pm when I can try the linking and let you know. I’ve already set the other zones as not used but it made no difference, however, it’s possible with powering on and off so many times the...
  8. N

    System setting fault on empty zone

    Good morning all I’ve been searching your forum but haven’t found anything like my problem. I have just bought the following: Honeywell Accenta Mini with LCD remote keypad. (8SP399A-UK) ADE Reson8 bell box. 3 x Honeywell IS312 PIR motion sensors. To make life easier I decided to put the system...
See more
Back
Top