Recent content by NoIdeaWhatImDoing

Does anyone else have any thoughts?

Hi Frank, thanks for the reply. Its a twin impeller pump so both hot and cold will stop flowing at the same time, therefore I would have thought the temp would stay roughly the same and as you say, the shower has a temp control built in. Besides that, the kids are hers, not mine so no need for...

Hi all Have salamander ct50+ shower pump. Like many other teenagers, mine stay in the shower untill the hot water runs out, or I boot the door open and drag them out. I was thinking of introducing a time lag switch to the pump mains supply, that will need to be pressed before getting into the...

Well I might as well talk to myself

Decided to put a 22mm outlet on the tank. Thanks for your comments though!

Hi There I am looking for comments/thoughts/advice. I need to install a shower pump. Instructions say that the pump (twin impeller) hot and cold, must be fed by 22mm pipe. Currently I have two mixer showers fed from the storage tank by independent 15mm supply's direct from the cold water...

I wasn't expecting a debate but it is quite interesting to read. Just out of curiosity I happen to note that the gas cooker, with a power supply for the ignition is fitted with a 13amp fuse. Couldn't find a rating plate on the cooker but the manual says that it should have a 13amp fuse...

Thanks. That was fast. I wont ask why it's Input :)

Hi Folks I have searched the forum but can't find the answer I'm looking for. I know that I need to find the wattage rating of an appliance to work out what fuse needs to fitted in the plug however, I have just been looking at my microwave rating plate which says Input Power 1200W, Output...