Recent content by Ojmk

I have completed commissioning mode - although I do have a question on that. If I now add a wireless PIR using the Learn option in the Zone menu - do I need to go back into commissioning mode ? I did add a test PIR last night using this option but not sure its working any better than the...

The next problem I have is that the wireless PIRs (4 off GBK 001) are really slow to respond - I can jump up and down in front of them and they don't respond - I'm using the "Chime" feature of the panel to test this. The wired PIRs (4 off ACF 001) work immediately as I wander around the room...

Hello and thanks for your response. I have resolved that issue now...… In Wintex on the Comms page under the "Radio-pad and COM Port Options" tab in the section called COM-IP Details.... I selected COM2 and added my local IP address.. However although this resolved the issue....from Wintex I...

Hi and thanks for the reply Lights on the Smartcom are as follows: 1st LED from left solid blue - I think this is connection to Texecom servers 2nd LED from left solid blue - I think this is Wifi 3rd LED from left not lit - I think this is ethernet cable which is not connected yet 4th LED from...

Sorry I should have added that I'm using Smartcom over wifi - I have put in ethernet cable but not connected the other end yet.

Hi Guys, I am having the same issue with identical setup; Elite 64 panel and Smartcom. The versions are the same too. I've tried the steps above, i.e. disabling ATS monitoring but still no luck, restarting Smartcom module by powering down. Below is a snapshot from WIntex of the system page...

Hi, have an indirect hot water cylinder, with boiler set to constant hot water, hot water runs out in 5 mins when showering. Flow and return to coil are both very hot, heating appears to be working fine if switched on. Used to be able to have many showers before water went cold, so this is a...