Recent content by Ollie9

When my previous switchmaster valve 'blew-up' I removed the electrical part and manually adjusted it daily until I could afford a new 3 way valve. Can this be done on the Honeywell??? I.e. remove the motor and just use it mechanically??

Hello team, I have also had problems with this set-up. I changed from an old switchmaster in the summer, everything seemed ok but I was only demanding hot water....until last weekend when I tried to put my heating on! I have just been through the wiring (including the colour changes for...

oh dear, someone please help, I thought that I had this problem sorted, but when I switched the heating on for the first time it won't work, I think it may be wired incorrectly as when heating comes on throiugh timer the pipe from the valve to the heating goes cold! But when the water is working...

Hello, in the summer I replaced an old Switchmaster (I think) with the Honeywell 3 way valve. I took advice from here and re-wired, all ok until I tried to turn the heating on last weekend, I think it may be wired incorrectly, as when I put heating on constant the output pipe to the heating...

I worked out that the Red and Orange from the Sw/Master needed to link so linked the terminals that they came from, all seems ok now! Thanks for your help.

I've taken off teh Switchmaster Valve, ordered a new Honeywell. Replaced fuses and voila all seems ok on face-value. BUT NO! It is all lit-up, timer works etc, but nothing is firing. Do I need to put a link-in somewhere now that the motor has been removed from the valve? It seems like...

Ok, thank you, will give it a go tomorrow. There should be juice to the boiler, pump etc as the Timer is all connected through a junction box. I have just ordered a Honeywell V4073A so will swap it in a few days, subject to the flippin' Post Office strike! Can this be done by turning the...

Thanks doitall, Is it just a case of disconnecting the wires and leaving the blue box in situ until I get a replacement Honeywell? Or do I remive completely and wind the valve manually to the water setting by hand?

Can anyone advise whether it is possible to disconnect the Blue Box and still use the system, stuck on water or C/H? Until I get a new valve. Also, which is the most preferred replacement? Any advice would be gratefully received. Ollie9

Machine will not start when start/pause button is pressed. Any one know how to resolve?

Hello again! I've cleaned out the filters and checked the water supply and pressure.all ok. Switched on again...no change. Having read the book again this am, I reset the m/c using the BLACK dot which seemed to do the trick! The m/c started and filled and completed a No.8 wash cycle then...

The handbook/manual that comes with the M/C says nothing about flashing light as being a fault error code. Sorry

I'm not sure what three flashes means, I saw a previous post that said it can give a clue. There is no hot OR cold water coming into the machine. And if I try to put it on spin it just rotates the controller.

Seems to flash 3 tmes.

Hello. No, it will not fill at all. I have switched it off for half an hour as it has been going for a while, I will then count the flashes on the indicator? Will this give us more clues?