I am taking apart the old t&g reveals on a few windows to insulate, and plan to replace them with plaster....just looking for a few pointers.
Planning to board onto blockwork with foam adhesive, and bead the corners, but then have to plaster into already painted walls. How do I best prep them...
You were dead on Burnerman....motor bearings it was again! I worked some fresh grease into them to keep us going until the new ones arrive....and we are back running as sweet as a nut. I was sure it wasn't the motor bearings again as the noises were very uncharacteristic....but there you...
We have an older Bentone oil boiler. It has recently developed an issue on cold start whereby it is quite loud with a squirrely squealing type noise. This subsides after about 5 - 10 minutes of use and settles down to quiet.
I will take off the motor tomorrow and check the bearings, but I think...