opps's latest activity

  • O
    opps replied to the thread Exterior Paint already failing.
    Sorry, when I recommended OB1, I thought you were talking about where the panel meets the door. The crack in the middle of the panel...
  • O
    opps reacted to Harry Bloomfield's post in the thread Cordless mini chainsaws - ? with Like Like.
    Brushless, are a big step-up, in reliability, compact power, and efficiency. Instead of a commutator, and carbon brushes, doing the...
  • O
    opps reacted to foxhole's post in the thread Liner for a wood burn stove. with Like Like.
    Liner ensures no escape of fumes etc if chimney is not adequate and aids efficiency.
  • O
    opps reacted to BenB1981's post in the thread Internal wall reverse Z bulge with Like Like.
    Hi I will do. I'll update after they've been next week. They are wall repair specialists. It's actually a 1930s house so pretty old...
  • O
    opps replied to the thread Internal wall reverse Z bulge.
    So it is a relatively new build? Most of my work is victorian houses. I am a decorator rather than a builder, they have solid 9" walls...
  • O
    opps reacted to BenB1981's post in the thread Internal wall reverse Z bulge with Like Like.
    Ah right, cheers. I've tapped the Z shaped now and to be honest it sounds the same as the surrounding area. It seems like the plaster...
  • O
    opps replied to the thread Nut/Bolt Type..
    Yes, they look like a cam lock. I have only worked with them once. I had to lock an Iroko worktop to an Iroko end panel ( both 2" thick)...
  • O
    opps reacted to motorbiking's post in the thread Nut/Bolt Type. with Like Like.
    cam lock https://www.screwfix.com/c/screws-nails-fixings/cam-dowels-locks/cat7280104
  • O
    opps reacted to big-all's post in the thread Routing bullnose with Like Like.
    you need a smaller radius for 18mm or a flat off around 3-4mm for the bearing to run on meaning the arc will finish 1-2mm short off the...
  • O
    opps replied to the thread Internal wall reverse Z bulge.
    Assuming that the ridge is new, the plaster has cracked. Lining paper is pretty good at dealing with minor cracks. When they get bigger...
  • O
    opps replied to the thread New doors fitted ..Have they been bodged ???.
    Image #2 the gap directly above the handle looks iffy. It doesn't seem to be constant. it might be a trick of light in the photo, but...
  • O
    opps replied to the thread Routing bullnose.
    I normally use my 1/2" router with those kind of bits. I do a full pass and then a reverse pass to reduce any "chatter". But there is no...
  • O
    opps replied to the thread Liner for a wood burn stove..
    I don't know if it is a legal requirement. I have a few friends with them. They had liners fitted to reduce the risk of the victorian...
  • O
    opps replied to the thread Internal wall reverse Z bulge.
    Difficult to say from here. If you are lucky it might be possible to lock the blown plaster in place (assuming that it is blown and...
  • O
    opps replied to the thread Can you buy Purdy soft paintbrushes.
    Emulsion is relatively thick. You don't want a brush that is too soft.
Show older items
Back
Top