Recent content by P.S.

The system isn't the issue, it's the terrible way it's been installed :/

One for each hander

The release is on a yale lock and so an emergency door release isn't needed. .. However ..... I'm going back in a couple of day's to continue with another door entry system that the same company had "played" with, bypassing an emergency door release for a maglock, as it was activated by...

Thanks for the comments thus far. ...and yes the cables in the trunking should be segregated as the twisted pair does not meet the highest voltage present in the trunking (if I understand band1 and band2 circuits correctly) So, in essence, and without going into any detail, it doesn't comply...

Yes, I thought at the very least all the PSU's should be in their own enclosure - It's just very shoddy imo

Was asked to look at this Enterview door entry system ; 1 external speaker/camera 1 door release 4 x internal intercoms All intercoms ring, have 2 way speech but show a blue screen on video. I did some research and obtained a copy of the install manual. It advises a voltage test at each...

call to honeywell tech support (seems to be offshore :? ) and they apologised that indeed the incorrect manual was sent with the panel. new manual on its way edited to say : 7meg pdf manual arrived by e-mail from india 7hrs later :shock:

nope, not out of depth and or frustrated, and there was never an issue with the strobe + ? as my first post shows (n/a = not applicable) the issue is the manual that came with the panel does not match the panel.

it's scrollable option through the usual languages, and throws out the programing sequences from 5 and above... gonn get on the case with honeywell tomorrow - thanks

compared to the galaxy (I've seen the programing manual for that) this should be a breeze ;-) seems the manual is mostly right with the exception of program 5 "language"

yup tha works (and no connection to strobe+) but ANNOYINGLY the manual that came with the "Accentra G3 compact" says "Gen4" and the "G3/G3 compact" manual I downloaded do not match up with the program sequences that are displayed ont he actual panel LCD !! as follows ! CODE..... PANEL...

bell set to SCB panel....................bell return >>>>>>>(T) scb Hold - >>>>>>> (A) scb Hold + >>>>>> (D) bell + TC - >>>>>>>> (B) Bell - STB - >>>>>>> Strobe - n/a >>>>>>>> Strobe + cheers

cheers, I'm sure I'll have a few more questions when I start getting through the programming.... Although I'm trying to help by getting a basic alarm working asap, would it not be advisable or even a requirement (ie for insurance) that he uses a "qualified" installer ? And if it is, what...

a mate got let down by his sparks, fitting a eurosec cpx alarm panel. All wires have been run to pirs and contact switches back to the panel. There's a honeywell bellbox sitting in a box too. 1) I was wondering which panel terminals match with the bellbox. on the panel I have SAB TMP...

Sorry to hear of your problems. Mine, however went faultless, two sink cut-outs, three tap holes, worktops, range splash-back, upstands and a window cill. It is, unfortunately all down to templating.. they had no on-site modifications to do at all.... Although can be quite common... Just...