Recent content by PatrickB

  1. P

    Mains supply suitable for unvented cylinder?

    Thanks for all the feedback! To address a few of the points: Not sure that 3.2bar was the static pressure - that was the reading at the same time as doing the 12l/min measurement on the kitchen tap. I don't think the tap was limiting the flow though because when another tap in the house was...
  2. P

    Mains supply suitable for unvented cylinder?

    Seen some good advice on similar topics on this forum so hoping for some advice. New to this so please excuse misused terminology! Having a new CH and HW system in my house (typical 3-bed semi, one bath, one shower, considering a future loft conversion with additional shower). Trying to...
Back
Top