Hi there
The shower electrical guide states the shower is 240V @50HZ to be connected via a dbl pole fused switch 3AMP fuse. recommend 2.5mm 2 cable although 1mm 2 is acceptable...
The shower max load is 150W...All the circuits are protected by circuit breakers...Very sensitive if a light...
Sorry about the delay...It is a Mira Vigour Power shower with the pump built in...The FCU is connected as follows...2 N in 1N out...2L in 1 L out. When I say I assume it's the Heater I only say this as that's the only other electrics in toilet (although heater has been removed and wired socket...
I am fitting a dble pole fused switch to isolate a power shower in the bathroom. There already is one fitted outside which I assume is for the electric heater. The qustion is can I just take a spur from this switch and connect it to a new Dble pole switch and then connect it to my shower?