Recent content by pda

anybody any diagrams on fitting lead flasing to a slate mono pitch roof adjoining back wall of a house???????

im replacing 2 timber heads on an old victorian house they ar both bays one on top of the other. Am continplating removing front of dwelling from ground to roofing joists??? as i also have to splice the flooring joists on the first floor around the heads. Any advise would be helpful. Thanks

it is perfectly safe the total number of spurs should not exceed the total number of socket outlets (unless fused spurs fitted) as long as the 16amp socket outlets comply with BS 4343 and the maximum demand is known not to exceed the rating of the overcurrent device which in ur case is 16amp

as far as im aware its ok the way it is. its only if there is a bath or shower in the room.

The way i normally wire them is to get a weather proof box put a 1way consumer unit in it fit a 30ma rcd and position somewere handy i normally put on wall under bath and spur it off ur ring main with a 5amp fused spur

U need to connect ur earth to ur earth bar at the cu. voltage is leaking to all the earth conductors in the wire. been there done that :D