Recent content by Peco141

I think you're right re broken fibreglass. Is the repair easy? Can this be done without removing the bath?

Oh, :oops: :oops: :oops:

Excuse my ignorance but I'm not entirely sure what you need a picture of. Let me know and I'll get one uploaded though. All help is much appreciated.

What do you mean a photo of the bath waste from the inside bath side?

Ok this is the likely course of action. The problem is the bath panel was fitted then the sink which in turn means the bath panel can't be removed without breaking tiles and removing skirting from the door frame. Nightmare!!

I thought so. I have no experience on fitting bathrooms or this sort of thing. Whoever installed this bathroom, it would seem has a similar level of bathroom fitting experience as me... none. If you're bored see my posts about the leaking shower and the problems I have with that. Anyway, I...

My waste bath pipe in the pipe in the picture below appears to be the wrong angle to allow for natural gravity drainage. I've had a few leaks underneath the bath and this caught my eye. Water does drain out the bath but can be fairly slow. Is this something I should be concerned about?

Little update, the replacement cartridge fixed my problem FYI.

Yeah I tried that but cannot find that part on the Mira page or even within the manual. http://www.mirashowers-store.co.uk/categories/parts-and-accessories/spare-parts.aspx

The pipe moved a couple of ml. But not sufficient to make a difference. I'll try new rawl plugs but would like to replace the whole piece if only I could source it/find out what it's called.

Post edited above to include pictures. Yeah the bottom screw turns.. Try longer screws?

Is that easy done? Also Andy can you tell me what the fitting is called in this picture? I'm not sure if I can replace the blue washer within it or if the whole thing needs replacing? I have the smallest leak coming from it. It's trickling straight from the back of the green bit down the...

Additionally, the installation instructions clearly state: Note! Make sure that the Filter Plugs are positioned to the front (i.e. Hexagonal Key facing forward). Guess which way mine were facing.. Can't replace the filters. :( Cowboys fitted this bathroom I swear it.

Cartridge replaced. Not fully tested yet as I have a small leak coming from here: Can someone tell me what this part is called so I can research it? Also should there be any seals on this part?

Thanks Andy