Recent content by Peter’s

Hi I have had another look and the black wires go to the tamper switch and on the new panel they are on the other side of the panel thanks for your help

Thanks for that , what do I do with the two blacks at the bottom in micro B terminals, it already has a black wire at the top? regards Peter

Hi It’s a kinetic az-tech old box wiring attached Thereis a micro jumped and two black wires in the bottom two micro terminals

Hi This bell box states it’s compatible with g4, it does not have the micro terminals like the old one, what do I need to do with these? Also there is a white wire in my old box not connected?

Hi What would this stop working? As it appears to be working ok ? What would you replace this board with please?

Hi Everything appears to be working, what does that control ?

Thank you

Ok thank you for your help, is the black and red in the bell terminals going to the original internal sound bomb, and do I just connect the r& b on the additional bomb to these so they both activate on trigger?

I don’t know, the alarm was fit. an electrician . What would this do ?

Hi I have checked the ma consumption and below 1 amp so good, do I connect the additional siren to the bell terminals at the bottom of the board or the sound on the left hand side of the board please? regards Peter

Thanks I will check I only have the bell box sounder and the additional one

What damage could it cause please

Hi thanks for the reply, if I was to get the two siren version for the additional one instead of the four would that be better?

This is how the panel is wired regards Peter

Hi I am wanting to fit an additional one of these.