Recent content by pezperry

  1. P

    vaillant ecotec 831 leaking

    I have a small leak coming from the bottom of the boiler at the front right hand side. I found a fair bit of water on first discovery and I have since placed a tray underneath, yesterday there was no leak at all, however today there has been a small leak. Sounds like a similar problem to the...
  2. P

    Any alternative to plywood under new vinyl floorcovering?

    Hi, I have recently had 6mm ply fitted over my kitchen where there were original floorboards, I will be putting vinyl down. In order to prepare for the vinyl, what do people reccommend for getting a smooth finish between the seams and where the sink holes for the screws are. I was going...
  3. P

    Hello, how did you go with your Ecotec Plus 831 loosing pressure, it sounds like I am having...

    Hello, how did you go with your Ecotec Plus 831 loosing pressure, it sounds like I am having exactly the same problem as you had. What was the cure?
  4. P

    Vaillant ecoTEC plus 831 low/high pressure problem

    Hmmm sounds expensive, slightly frustrating that I am having this problem so soon after having the new boiler installed. Oh well, I will post the results up soon. Thanks everyone for your help.
  5. P

    Vaillant ecoTEC plus 831 low/high pressure problem

    Thanks for the advice. The pressure does not increase that much, therefore I guess it would be a leak somewhere. I am fairly sure the outflow pipe that sticks out the exterior wall is not leaking as I have been checking it regularly. I will check the radiator valves tonight. Would it be a case...
  6. P

    Vaillant ecoTEC plus 831 low/high pressure problem

    I will get in touch with the installer. When the heating comes on, the pressure gauge tends to increase, same with the hot water. When I top up the system using the valves at the bottom (to mid grey section in the pressure guage) it steadily looses pressure over a 24hr period, eventually ending...
  7. P

    Vaillant ecoTEC plus 831 low/high pressure problem

    Hello, I had an ecotec plus 831 installed mid feb 2011, it seemed to run ok for around a month. I noticed one of my radiators had a large cold spot so I turned off heating and waited for boiler to cool sufficiently then bled the radiator, which took out a lot of air. Since then the boiler...
Back
Top