Recent content by Phil78

Hi all, i have a 94 sportrak with 93k on the clock, took it for its test and it needs a few jobs, the one im unsure of is emissions, the fail sheets states "exhaust emissions lambda reading after 2nd fast idle outside limits, LIMIT 1.030 / READING 1.930" i assume 1.930 is very very high...

Providing the post isnt cracked at ground level which would make it slack, dig round it and re concrete it :)

Stihl saw and diamond blade is what we used to cut pavers and kerbs like that with.

Hi aviva :)

You shouldnt have much problem removing it if its 13" when we used to take them out we used to dig round them with a narrow draining spade and cut through as many roots as poss with and old woodsaw and this usally slackens it off, you shouldnt have a problem removing it.

Not sure on the roof pitch but if it was me id be favoring the corrugated sheets over the felt. Phil

Hi Robby, im new too i only joined yesterday :)

This is exactly what i was thinking but just didnt understand what could cause it, im going to try moving the arm see if it clears it and if so il maybe have the cable adjusted a bit to see if it helps.

Havnt rode for a couple of years now, last bike was a 99 fireblade, the mrs done her cbt around 3 week ago and has a 125, shes not wanting to do a full test yet as she was unsure wether she would like motorcycling or not but she seems to be liking it so far even tho the weathers crap.

If its perforated pipe 60mm will be fine, i used to have a landscaping business and often drained gardens and that was roughly what size i used, just make sure you get plenty clean stone around the pipe so the holes dont block up :)

The suggestion the builders gave is the cheapest option, you shouldnt have a problem as its only a shed going on it, if you were driving on it that may be different, providing your lawn areas not a soft bog and you dont skimp on thickness it shouldnt crack or break up :)

As john says you can use drainage channels, another option which is cheaper providing you can get hold of some and not buy a whole coil is perforated pipe, you could dig trench along the edge of the patio and fit perforated pipe into it then cover with pipe bedding (10mm pea gravel) then top it...

Hi john no its when the pedal is up, when i press the pedal down the noise goes away, it was really noisy with the old gearbox on, with the gearbox i purchased and fitted its alot quieter, but still there.

Hi John i may take another look at the cable area see if that possibly could be the issue, other than that im out of ideas. Thanks Phil

Hi all im new :) Ive got a strange problem i hope someone may be able to point me in the right direction, for the last 6 month my thrust bearing on my alto has been whyning so i had last week booked off so thought il tackle it, i didnt skimp i bought a new bearing and new clutch too then it...