Hi people
I need to replace the top bearing as it has excess play for MOT
there is alot of axial movement as if the column is adjustable but this model doesn't have that luxury
do I have to take the whole cloumn out or is it possible to fit without doing that
Thanks for the above explaination it makes sense to me now
You will see from a reply to the post above that I have investigated further where the 240 volts come from at the old room stat.
I intend to link the live and common so that the contacts have a feed available when the temperature...
I think this is the advice I am going with as another reply explains the meaning of the 'volts free contacts' and I can see that the 240 volts does not go back to the boiler only to the mid-position value
I intend to get this done this week sometime so that any fireworks can be con strued as...
If you move the CH ON wire to the L terminal of the existing timer/programmer, you can put the receiver where the old stat was
I don't understand the need to change the wiring in the timer/programmer
The programmer is beside the boiler, which is a potterton suprema,
The room stat I want...
Hi people
I have purchased a wireless digstat+RF to replace my wired stat as I need to control a nursary not the stair well
The old wired honeywell room stat has 3 wires L, N and yellow on 3 call for heat
The RF603 wiring diagram states L, N 1common 2 cooling 3 heat.
I have not...