Recent content by PipG

Thank you both for your help and advice … will replace the trap !

Ahh that makes sense … so the black ring that fell out was just a bit of the inbuilt black rubber part! Is the inbuilt rubber part replaceable, or is that screw on part with the rubber inside still available to buy? If not I will buy the tape and do as you suggest. Again, thank you.

Yes, the black inside the base part is like a solid rubber liner .. the shiny bit at the bottom is just water. The seal that fell,out looked exactly like the new seal but broken. I will buy some tape and try that. Hopefully I can then remove the bucket ! Thank you very much for your help.

I have attached a couple more photos. The top part does not have a shoulder, just thread. Hopefully the photos will explain my problem.

Many thanks for your reply Apologies for my idiocy but this is totally new to me, am amazed I actually cleared the sink blockage. The O ring that fell out looks identical to the replacement, I thought it had to be. 32mm … are there smaller sizes and should the O ring fit halfway down inside the...

Having had a blocked kitchen sink, I removed the trap and a broken small round washer fell out. I had a replacement 32mm washer, more like a rubber band but not stretchy, but it seems too large to fit inside the bottom trap part that screws onto the pipe. Advice would be appreciated !

Thank you !

Thank you for that. They are stamped Nisco 22 864 so I assumed they are 22mm ?

They do look a bit grim but the rust is actually superficial and not eaten through.

I have just had a quote for removal of the asbestos - £220 plus VAT

These are also extremely old and lots of them - best for scrap ?

Thank you again - may try Ebay and emphasise that it is not to current regs.

Many thanks - will give it some thought !

Can anyone tell me if this huge and heavy isolator (probably 40 plus years old) is usable or is it scrap ? Dimensions are: 25" high x 18" wide x 10" deep 3 Phase 440V and neutral. 200 Amp. Imperial is embossed into body.