Recent content by Podbrook

Ah did it know that it could be separate as that was my initial question. I will have a hunt to find it. Cheers

Hi it’s at 1 just chimes when finally set. It’s the unsettling that’s more of the issue

Hi Sparkymarka the alarm seems to be working ok now so thanks for your help. The alarm sets silently apart from one beep when going to bed (setting 01). In the morning if you have forgotten to unset remotely and walk down the stairs it picks you up from the hall PIR SET as 09 but gives no tone...

Cheers I’ll check. Going to order batteries later. Can you recommend a particular quality transformer that will work with the system. There is still the original 1.5mm twin and earth from the old alarm system behind the bell could I still use that to connect to the delta circuit board and put...

If I have messed up the outputs ( don't remember going there but) what should they be set at?

that implies poor manufacture of the batter packs. are any better than others.

Hi again. There is a Terminal in the bell box on the motherboard that is marked as a 13 v DC input from a mains hard wired transformer. I take it this will relieved the need to keep replacing the battery and is it worth the option.

Hi. There is a distinct possibility of that as I was getting frustrated and went hunting. thing is the internal warning went off and siren low battery warning came on. I find it a coincidence that the siren disappeared off the system then the box couldn't be learned until I unplugged the...

Hi again. Got the siren learnt eventually but it is silent when alarm goes off nor does it strobe. Any ideas?

Cheers I will see if it works. Just got another one now. Bell stoped working and panel said no bell. so took it out and looks clean and dry but won’t go into learn after Ireinstalled the battery all leds are on solid no flashing and learn button does nothing.

Hi Sparkymarka. Just been looking at the alarm again and connected a new sensor. Problem found when testing. I can set the alarm tag key fob or code but only tag or key fob will disarm on entry. The code has no effect. Any ideas?

I’m also going to do some adjustments on the proximity tags and fobs so I may be back. Cheers

Hey Sparkymarka The alarm seems to be back now. Had to do the same action again to silence the key click but this time it accepted it by just setting off the alarm with the 485 coms lost. But after a restore/eng reset all seems fine. One more question for now is it possible to silence the tone...

Cheers I thought that may be the way we need to go. Thanks for your assistance and I will post the result tomorrow. Not to early I case the alarm goes off unhappy neighbours if it does.

Sorry just did that and nothing has happened.