Recent content by princejim

I have followed the programing in the book as the system works after a fashion, but the PIR trips imediately when walking away from the panel?

I have a simular problem. I have the g4 installed, test and all wiring ok, I have zone1 with a PIR next to the door and the control panel, z2 linked out, z4,5,6,7 to different rooms and z8 linked out, all on PIR's. I have set z1 as timed inhibit, but when I arm the system immediately I move from...

I have the g4 installed, test and all wiring ok, I have zone1 with a PIR next to the door and the control panel, z2 linked out, z4,5,6,7 to different rooms and z8 linked out, all on PIR's. I have set z1 as timed inhibit, but when I arm the system immediately I move from the control panel the...

I have the g4 installed, test and all wiring ok, I have zone1 with a PIR next to the door and the control panel, z2 linked out, z4,5,6,7 to different rooms and z8 linked out, all on PIR's. I have set z1 as timed inhibit, but when I arm the system immediately I move from the control panel the...

Thanks for the reply. However, I only want to use the PIR's and no contacts, final door is metal therefore, I have linked out the first zone. Still have the same problem??

I have just installed the Honeywell accenta/optima gen4 alarm systemonly using pir's and 1 PA, zone 1 is the exit PIR, zone 2 is strapped out not used, then zones 3 to 7 are used, all wiring correct. When I set the alarm on exiting the building, you get slow beeps untill I move away from the...