Briefly turns blue f lol ash for a while, when this happens I can set the system ok. I then walk to the house try to unset and re-set and the error message comes back 'not polling door 8 - all the other door and window contacts are ok and ready to be set, but the system sends the message "cannot...
My Pyronix home enforcer won't set.
I recently have an issue getting the system to set, it gives an error message -
1) door 8 - wirles supervn Fl
2) door8 - wirles Poll Fail
I've changed the battery in the door contact, I then go to the panel and reset engineer code and it resets at the...
Maybe the Drayton motor supply is not quite up to the job, and a Honeywell valve be used.
I swapped to Drayton because of the easily replaced actuator head, but see Honeywell now have caught up and market a similar replaceable head only, unit?
However, I will alter the hot water cycle to coincide with the heating-off cycle as suggested as a temporary repair method, untill this issue can be resolved, maybe.
Thanks for the reply and suggestion. Unfortunately, I'm an engineer who insists on knowing how everything works and needs to have systems working correctly! (It's an engineer thing!) - there's no reason why the valve should "stick" - it's all new, and replaced each time. So I need to establish...
Every one of the actuators has behaved in the same way - give the actuator head a clout and the system works again.
Funnily enough, the system always comes back on in the morning!
Which wire is responsible for driving the switches to the heating position? (The grey?) Does that get it's supply via the room stat?
Do you think the room stat is not sending enough current to move the motor towards the Heating position?