Recent content by pushrod

  1. P

    Light tripping RCD

    I am no expert as i said , but i suspect the emf would be higher and in any case much higher than 230. All the neutrals are connected. Rcds are normally earth fault devices as they detect an imbalance in live and neutral - i suspect this could trigger it as the neutral would have a bigger...
  2. P

    Light tripping RCD

    As coljack says there is a back emf from the inductance in the ballast there is also a capacitor ( the one for power factor correction) across the inductance and tube. It could be that this failing affects the ability of the circuit to deal with it. If this capacitor fails i believe the light...
  3. P

    Wall Removed - Couple Of Wiring Issues To Deal With

    that's right. :) JUst came on here to find out something about damp proofing but clicked on the wrong section :lol:
  4. P

    Wall Removed - Couple Of Wiring Issues To Deal With

    no problem as long as you can get to all the wiring - put one in parallel with the other.
  5. P

    Wall Removed - Couple Of Wiring Issues To Deal With

    1) Don't think screw connections ie junction boxes are allowed under the floor boards - need to look at other ways of joining the cables - crimping or other no-maintenance box? 3) think outside circuits are notifiable to LABC - otherwise ok 2) sorry can't visualise it
  6. P

    garden lighting

    obviously you know the layout best and lifting flags is a lot of hard work, but can you not come out of the wall and go up cross the path at 7 feet or so high and then come down a post?
  7. P

    garden lighting

    Although it is better to bury your swa it is not an absolute requirement. You could run it along a series of discreetly positioned posts so that you don't have to take up your new patio.
  8. P

    hot and cold pipes on the outside of the house

    Thanks for the reply - it's a diy on a house i'm doing up. Never come across armaflex lagging before - would that be available from a good plumbers merchant? I suppose if it does burst at least it is in the right place to minimise the damage :wink:
  9. P

    Extending a Consumer Unit

    What is power rating of the fire? Why not run the fire from a fused 13 amp spur on the ring? 13A should cope with a fire upto 3kW approx.
  10. P

    hot and cold pipes on the outside of the house

    Hi i know this is obviously not the best idea but is there anyway of running hot and cold water pipes on an outside wall (specially insulated pipes?). I need to take water up to an upstairs bedroom and running them internally would be a major problem due to position of stairs etc. cheers.
Back
Top