Recent content by pwalker

I thought about the seal you mentioned nick, I have'nt seen it as I've not done anything yet. I imagine it to be that corky type stuff that gaskets are usually made from. So it could tear if it stuck to one of the surfaces. In which case I'd assume I'd be able to get a replacment/

I realise the combustion products need to be checked due to the nature of the fault and solution ,so wouldn't simply just not do it. The reason I would get some one in to check the flue is because I don't have a FGA, and the work involved for the person doing the check (provided results ok) is...

I've got new o rings to replace the one on the mating faces betwwen the gas valve and the gas valve stop cock valve, and also for the gas valve to manifold face. I would leak check any seals broken after anyway. So should be no problem regards leaks. The manometer is intrisically safe itself in...

I'm pretty sure its the valve, it is Open circuit between the two outer pins which the power goes to. There is about 1.4K between the top pin and the others (excluding earth!), but there it is open from the bottom pin to any of the others so maybe a dual coil solenoid with one faulty preventing...

suprima 30L fails to ignite. fan starts, igntion sparks but not flame. Getting 250 VDC to gas valve so assume PCB is not faulty in this case. Obviously this points to the gas valve (honeywell CVI 402550), my question is, is this a fixed range gas valve or will it require setting up on...