Recent content by quickfit

Hi all, i`m fitting a manrose inline fan to my shower room, i am struggling for space so want to know if i will be ok to drop the exhaust side of the unit down away from the unit about a angle of 45degrees and about 3metres long hose then to the outside, cheers mick

Thank you TTC :) Mick

penny as just drop lectrician, what you say is the 2 reds together away from the fitting and not connected to the L fitting connector .then the black to the fitting N connector and the black with the red tape to the L connector :) Mick

Thanks for the speedy reply lectrician, so what your saying is i connect the black wire with the red tape on into the connector with the red wires, :) Mick

happy new year all, ive got a single bulb light fitting in my garage, the wires are as such in the L section there is a wire for the bulb then a black wire with red tape on it, next section Loop 2 red wires, next section N a black wire then the other wire for the bulb, the other light i want to...

hi all,i`m going to be removing some radiators but when i come to refitting rather than use PTFE tape what paste can i use in its place to seal the treads cheers mick

hi all, i removed a single radiator and tried fitting a towel rail, big problem the pipes are about 20mm from the wall and the connection for the rail are about 70mm from the wall, is there a easy way round this, also my heating system is on a combi boiler do i just turn the water off under my...

hi all, could anybody please tell me were the sensor for checking the surrounding air temperature on my fridge/freezer is located on it

hi all, i`m going to build a raised flower/veg bed single brick wide 4-5 course high , can anybody tell me how big a footing H-D-W i should put in, cheers mick

hi crazydaze, the floor was level and not loose or uneven just like the one floor that i did without nailing, all floors were layed on special sticky one side under lay which we got with the boards

hi all, i laid a floor using 20mm hardwood engineered boards on a floating floor and made the biggest mistake possible by nailing them down so now they creek like mad when you step on them , can anybody give me some surgestions how to stop them creeking with out taking them up, i also layed the...

8)

hi all, last year had a freezer go down in the garage due to the cold weather, so have bought a small chest freezer, to protect it from the cold have thought about putting polystyrene sheets around it and on top but leaving a gap between them and the chest, what do you think !!! cheers mick

hi masona, when i said it works fine i should have said it works when the door is open but same problem when the door is shut, cheers mick

hi masona, did that and it works fine, cheers mick