Recent content by Quoin21

  1. Q

    Whirlpool Dishwasher ADP4500 - starts but will not run

    My Whirlpool Dishwasher ADP4500 has not been used for a year until a month ago when it failed to run but having poured some very hot water into the sump it ran fine. The same thing happened 2 weeks later but on the third occasion today, even with the hot water it failed to go beyond the...
  2. Q

    Help needed about Tar Paint ? for underground timber

    I am about to put 4 columns for a water tower on their foundation but being old seasoned timber (300mm x 300mm & rough) it is not impregnated so I need to coat it with something that will keep it rot-free for many years. I gather there is tar paint but this may be biodegradable so may not...
  3. Q

    Sharp Television 66ES - 27 inch with surround sound - dead?

    The television has died. The 3 amp fuse on the main board blows dramatically when plugged in. Any ideas or do I scrap it? Thanks
  4. Q

    Whirlpool Dishwasher ADP 4500

    Gosh, what a knowledgeable person you are. I have been using tablets and not topping up the salt so I will now do that. I hadn't done because the 'salt' neon had not come on. Your point is reinforced by my discovering that the base of the inside was covered by a slimey film and the dishes...
  5. Q

    Whirlpool Dishwasher ADP 4500

    Thank you again. Before I saw your reply I tipped it fully on its side, and mopped up the water. I then took off the base to see what I could see and tapped a few things and pressed a few connections and it worked. There is a quite large opaque vessel (in the back left corner) into which the...
  6. Q

    Whirlpool Dishwasher ADP 4500

    Thank you such a prompt reply. That worked, machine started by pumping out small amount of water but then hung, making quiet whurring noises but seemed to take in no water. After some time it stopped making a noise. I disconnected input hose and there is plenty of water pressure. Have also...
  7. Q

    Whirlpool Dishwasher ADP 4500

    2nd user machine but has worked OK for months. No instruction manual. Today set it to run. Pressed 'ON' button. Green neon by 'Start' button started flashing and pressing the Start button has no effect. What should I check or do? please
Back
Top