Hi all.
My 1st floor bedroom floor is wonky. Drops unto 40mm from edge to centre - looks like bowed joists. I'm loathe to sister each joists with new timber and someone suggested just shimming the joists - add a strip of wood to the top of each joist with varying thickness to create a level...
I had the common Miele Dryer issue of starting a cycle then switching off after 30 seconds or so. And also the issue a cycle running but no heat.
I tired the NTC switch etc and none of that worked.
Finally I got a Miele engineer round and he said it was simply that the mesh vent strips that...
Hi all.
Trying to find what this fault code on my T294C Dryer means:
It starts up but does not heat up. Have had previous faults of starting up with heat but then shutting down after a few minutes with beeps.
I have trued a new Miele NCT (temp sensor) which made no difference.
Wiping the...
Hi all.
I have the seemingly common fault of my Miele T294C dryer shutting down after 5 mins of blowing cold air and beeping on all settings.
BUT!
If I wipe / clean the door interior seal down (on the machine body side not the actual door) it will work???
Would appreciate any pointers as to...
Hi.
I don't see why it would say Exceeded Drying Time when its a fully automatic dryer - can it exceed drying time?
Also, when it fails it fails within 5 minutes - so F55 does't make sense.
I'll strip it down to test the various bits as Zipper describes but just wanted to see if I could...
Thanks for the reply - don't think its the heater element as every now and again if I clean the lint trap out or mess with the door it will work again, on - which its doing now.
But the failures are getting more frequent now. What I really would love is if someone could decode the error code...
Hi all.
I'm new here and ready to take fate into my own hands.
My Miele dryer is refusing to dry anything. Bleeps and reverts to cool air mode after a few minutes. Timed drying does the same.
I know this issue is a common fault and have read the many fixes offered by the member 'zipper'...